Shifty triangle mittens pattern

Stranded knitting.
Knitting in the round.
Decreasing.
Picking up stitches.

If this is your first try at a mitten, you might want to look at another, more descriptive pattern too.  This is a simple pattern for experienced mitten knitters.

Do you want a pdf copy of this pattern?  Click this!


Yarn: Drops Delight,
         Color nr 10
         50gr = 175 meters (1,76 oz = 191 yards)
         I used about 75 gr of yarn for my mittens.
Tension: 26 stitches x 34 rows = 10 x 10 cm (4" x 4")


Needles: 2,5 mm double pointed needles/US 1 or 2


Pattern:

The yarns is varigated and knitted stranded, using either two balls of yarn or one strand from the outside of the ball and one strand from the inside of the ball.  This causes the shifting of colors throughout the  pattern.   The two strands of yarn may become very like in color during your work.  If this happens cut one strand (and secure in the stitches weaving in the end) and discard enough yarn to clearly see the shift in color between the strands. Secure the end in the stitches and start again. 

Cast on 66 stitches.
Divide stitches on needles, 16+17+16+17.
Knit one closing the round, making sure the stitches are not twisted.  Continues knitting 2 rows in one strand of yarn.

K1 in the lighter shade, p1 in the darker shade.  Repeat for 2 rows. (or more according to tase)

Knit one row in the darker shade.

Start diagram nr 1:

Shifty triangle mittens diagram nr. 1

The two sides of the mitten are not equal, just continue the pattern on the round. (Do not start over the pattern on the second side!)  The blue line is a scrap thread of different color that will make the thumb: knit the scrap yarn over 14 stitches, put the stitches back on your right hand needle and knit them again acording to the diagram. (This is only done on the back side of the mitten, on the front side:  keep knitting the diagram)  Make a thumb-thread for one right hand mitten and one left hand mitten.

Make note of this, I have made several pairs of mittens that have the thumb on the same side, it's very easy to miss...  But of course, you are smarter than me!




Continue knitting the diagram.
When you get to the decreases, I found it easier to make the decrease with both strands of yarn.  If you do this make sure you are really decreasing as you should, since you've got two strands of yarn in the last stitch.

For the right hand decreases I used a k2tog tbl.
For the left hand decreases I used a k2tog.

When the diagram is finished, cut your yarn, pull the ends through the remaining stitches and secure them well, weaving them in the stitches on the back.


Thumb:

Pick up the stitches on both sides of your thumb thread, adding two stitches on each side making 16 stitches on each side of the thumb.

Knit according to diagram 2:

Knit  in the same way as the mitten, the back side is the same as the front. The pattern is a 2x2 stitch square as seen in the drawing.   When weaving in the ends make sure to sew closed any holes between the thumb and the mitten.

Wash and block.

Good Luck!